• Skip to primary navigation
  • Skip to main content

Instrument In A Box

  • Home
  • Products
  • Contact
  • About

Retrofit Hit and Hold Solenoid Valve Driver – 1 Channel 5 Amp

$24.98

Category: Hit and Hold Retrofit

DC 5 V, 12 V, 24 V Solenoid or Fluid Valve Driver 1 Channel 5 Amp Retrofit Hit and Hold

  • Description
  • Reviews (0)

Description

The HitAndHold.com Retrofit Solenoid Valve Driver can be inserted into the wires of your existing design. The driver has two input and two output wires that are soldered in series with the existing wires going to your solenoid valve. When power is applied the driver turns on with zero latency and applies full power to the solenoid for 500 ms, the driver then cuts back to a user selectable 50% or 66.6% duty pulse width modulated drive. 50% represents a cut back to 25% power and 66.6% represents a cut back to 36% of original power dissipation. The reduction in power dissipation, reduces heat load locally such that fluids do not get over heated, and also reduces total thermal load in an instrument.

A – Select resistor A 100 ohm 0402 size for 66.6% duty (installed as sold)
B – Select resistor B 100 ohm 0402 size for 50% duty
Do not hot swap solenoid.

Download Data Sheet

Specs

Part NumberHNH-01-500-66-0530-05
Input Voltage5 V - 30 V
Max Load Current5 amp
Hit Time500 ms ± 50 ms
Hold TimeInfinite
Reset Time/VoltageLess than 2 V for more than 10 ms
Wire Gauge14 AWG - 24 AWG

 

Suitability of Use:

Suitable for use in solenoids where the magnetic loop reduces as the solenoid pulls in. Such that the much less current is required hold the solenoid in place than to initiate the stroke. May require higher PWM hold % for pinch valve type solenoids where the load increases significantly as the tube is pinched (contact factory for customization).

 

Power on Rise Time:

The power on “hit” time count starts when the supply exceeds 4 V, therefore the power input must turn on with a reasonably fast rise time in order to get 500 ms of “hit” time. Generally, this is not a problem because most devices will turn on in less than 10 ms, but is noticeable if for example the voltage is being gradually increased from a lab power supply.

 

Reset Time:

The “Hit” time counter resets if the supply drops below 2 V for greater than 10 ms

 

Customization

Custom designs such as higher voltage, higher current, shorter hit time, miniaturization, custom PCB layout to fit around existing hardware are available. Please contact Factory at support AT HitAndHold.com.

 

HitAndHold.com

Made in the USA

With Components from Franchised Distributors

90 Day Money Back Warranty

Reviews

There are no reviews yet.

Be the first to review “Retrofit Hit and Hold Solenoid Valve Driver – 1 Channel 5 Amp” Cancel reply

Your email address will not be published. Required fields are marked *

Related products

  • Retrofit Hit and Hold Solenoid Valve Driver – 4 Channel 1 Amp

    $44.98
    View Product
  • Retrofit Hit and Hold Solenoid Valve Driver – 1 Channel 1 Amp

    $17.98
    View Product

© 2023 · Instrument In A Box