The HitAndHold.com Retrofit Solenoid Valve Driver can be inserted into the wires of your existing design. The driver has two input and two output wires that are soldered in series with the existing wires going to your solenoid valve. When power is applied the driver turns on with zero latency and applies full power to the solenoid for 500 ms, the driver then cuts back to a user selectable 50% or 66.6% duty pulse width modulated drive. 50% represents a cut back to 25% power and 66.6% represents a cut back to 36% of original power dissipation. The reduction in power dissipation, reduces heat load locally such that fluids do not get over heated, and also reduces total thermal load in an instrument.
A – Select resistor A 100 ohm 0402 size for 66.6% duty (installed as sold)
B – Select resistor B 100 ohm 0402 size for 50% duty
Do not hot swap solenoid.
|Input Voltage||5 V - 30 V|
|Max Load Current||1 amp|
|Hit Time||500 ms ± 50 ms|
|Reset Time/Voltage||Less than 2 V for more than 10 ms|
|Wire Gauge||20 AWG - 28 AWG|
Suitability of Use:
Suitable for use in solenoids where the magnetic loop reduces as the solenoid pulls in. Such that the much less current is required hold the solenoid in place than to initiate the stroke. May require higher PWM hold % for pinch valve type solenoids where the load increases significantly as the tube is pinched (contact factory for customization).
Power on Rise Time:
The power on “hit” time count starts when the supply exceeds 4 V, therefore the power input must turn on with a reasonably fast rise time in order to get 500 ms of “hit” time. Generally, this is not a problem because most devices will turn on in less than 10 ms, but is noticeable if for example the voltage is being gradually increased from a lab power supply.
The “Hit” time counter resets if the supply drops below 2 V for greater than 10 ms
Custom designs such as higher voltage, higher current, shorter hit time, miniaturization, custom PCB layout to fit around existing hardware are available. Please contact Factory at support AT HitAndHold.com.
Made in the USA
With Components from Franchised Distributors
90 Day Money Back Warranty
There are no reviews yet.